Lubrication tips HelteRennet 2026

Here are lubrication tips from SkiWax based on the weather forecast from Yr 27.02.2026 at 16:00.

Download lubrication tips as PDF here

Glide:
1. Clean the skis (gliding zones) with ski cleaner. Let dry.
2. Brush the sliding zones with a rotary brush or hand brush. Use a steel and horsehair brush. Wipe with paper.
3. Now the skis are cleaned and you can add glides.
4. Option 1: Apply Yes Roto Speedline 5 on the sliding zones with a wool roto and then brush with a blue nylon brush (roto brush or hand brush).
5. Option 2: Melt in SWIX PS6 glider. Cool, drool away the slider and brush well with steel, horsehair and nylon. This option can be combined with
Option 3 a) or 3 b).
6. Option 3: a) Apply SWIX HS10 Liquid. Let dry and finish by brushing lightly with blue nylon. Or:
b) Apply STAR Liquid Warm. Let dry and brush lightly with blue nylon.

Celebrations:
1. Rub the attachment zone with 80 or 100 grit sandpaper. The length of the attachment zone varies depending on the characteristics of the ski, but a length of about 50 cm is often appropriate on most racing skis. Stop the attachment zone slightly in front of the heel.

2. Option 1: Stickers applied by hand

Primer:
Choose Guru Extreme Hard 39/SWIX KX20/Rex Blue. – Apply a thin layer to the entire lubrication zone. Melt lightly with a grease iron. Cool.

Today's party:
Guru Extreme Hard 39: – Apply a new thin layer of adhesive to the entire lubrication zone. Cool. – Apply a new thin layer to the tread. Cool. Leave outside overnight. If this becomes too aggressive, you can adjust with blue/violet wax over the adhesive.

Today's party if you don't have Guru Extreme Hard 39: Choose SWIX KX 35N: – Apply a thin layer of adhesive to the entire lubrication zone. Cool. Select SWIX KN44 Nero: – Apply a thin layer to the tread. Cool. Leave outside overnight. If this becomes too aggressive, you can adjust with blue/violet wax over the adhesive.

3. Option 2: Glue with a glue gun Set the temperature of the glue gun to 140 degrees. Empty a tube of Guru Extreme Hard 39 into the glue gun.

Primer:
– Roll out one short layer about 20 cm and one layer in the entire buttering zone. Melt lightly with a buttering iron. Cool.

Today's party:
– Roll three short layers and three long layers. Let cool. (Number of layers depends on the properties of the skis.) The skis should be left cold (outdoors) overnight. If this is too aggressive a bond, you can adjust with blue/violet wax over the adhesive.

4. Option 3: Glue with a lubricator, slightly less aggressive than option 2. Set the temperature of the lubricator to 140 degrees. Mix 1 wax Rex Blue -1 -4 and 1 stickers Guru Extreme Hard 39 in the lubricator.

Primer:
– Roll out one short layer about 20 cm and one layer in the entire buttering zone. Melt lightly with a buttering iron. Cool.

Today's party:
– Roll three short layers and three long layers. Cool. (Number of layers depends on the characteristics of the skis.)
For more hold: Apply one thin layer Guru Extreme Hard 39 ev. Swix KN44 Nero.

Download lubrication tips as PDF here

SEE YOU ON THE TRACK!